What it means
Your internet connection is fine. The Wi-Fi signal does not reach the far rooms well.
Walls and distance are the usual cause, which is why the first fixes are about where the router sits.
How we spot it
We need a survey with at least 10 measured spots. When 30 percent or more of the spots you walked are weak, we count that as strong evidence of a coverage problem. From 15 to 30 percent, it counts as medium evidence.
A mesh node whose own link back to the router is weak counts as well. On the map, a weak spot or dead spot is a cluster of two or more poor or dead places.
Free fixes first
- Move the router to a central, raised, open spot: out of closets and cabinets, off the floor and away from the TV. One good spot often beats any new hardware.
- Use 5 GHz where you can. Near the router, 5 GHz is much faster and less crowded than 2.4 GHz. If the router uses one name for both, it usually picks well. If not, join the 5 GHz network in rooms close by.
- Walk the same rooms again, then re-test.
If you already have a mesh node, check where it sits. A node placed inside the dead zone cannot hear the router well. Move it about halfway, or connect it with Ethernet.
Common guesses
- “I need mesh.” If the weak rooms are the far ones, moving the router to a central, open spot is the first thing to try.
- “Buy an extender.” An extender halves the speed it repeats, and a node placed halfway does better.
- “Mesh didn't help.” The node's own link back to the router is weak. Moving it closer to the router usually fixes it.
When hardware helps
When 15 percent or more of the spots you walked are weak, we may suggest a mesh node placed about halfway between the router and the weak rooms, or a wired access point connected by Ethernet. We say to try moving the router first, and we name no brands.
How Ground Truth checks this
The survey walk and the Wi-Fi map are free for one home and one floor. Scanning a floor plan needs an iPhone or iPad with LiDAR. Walk mode and uploaded plans work on any device.
An iPhone cannot read Wi-Fi signal strength, because iOS gives apps no signal strength. A Mac can measure it, and the Signal map layer, which shows those readings on the map, is part of Pro. When a Mac measures spots below -72 dBm in at least two places, we point them out.